|
CodiProg USB is a universal in-circuit programmer which allows to read, edit and write various types of
I2C, SPI and Microwire EEPROM memories and Freescale/Motorola micro-controllers flash and EEPROM.
Device communicates
with PC through USB port. It allows to fully adjust main programming parameters such as programming voltage i pull-up resistors. It can open, edit and save files in bin, epp, and sec formats. CodiProg USB software is able to upgrade device firmware to enable support for new options and memory types. It is also possible to use some CodiProg features, without PC control. |
The documentation is divided into following sections:
This section describes CodiProg hardware features such as pinout, supply voltage and component layout.
This section describes user interface, configuration options and basic operations.
This section describes how to upgrade device firmware.
This section describes jumper setup to run CodiProg functions without PC control.
This section describes Freescale/Motorola MCUs flash and eeprom programming.
List of all supported eeprom memories and Freescale/Motorola MCUs.
Information about common error messages and problems.
Information about changes in this release