BACK TO MAIN PAGE...
Error messages
- Can't read MCU
- CodiProg device is unable to read MCU status and ID.
- Check if you choose correct MCU and mask type.
- Be sure that all wires are connected to correct pins.
- Reset CodiProg device and try again.
- Use Selftest option and test adapter to check device.
- Remember to use 'Disconnect' option after finished work with MCU,
- Link Error
- CodiProg device is unable to establish connection with MCU.
- Check if you choose correct MCU and mask type.
- Be sure that all wires are connected to correct pins.
- Set wider range of linking parameters (frequency and phase).
- Use Selftest option and test adapter to check device.